2

I've just presented a new Sigma BC 1609 (wireless), assembled, put the sensor on the fork and a magnet on a spike, set the wheel size, looks fine. But the speedometer does not work - it is just flashing? Any hints?

Thank you.

update replied the question

Alex Buznik
  • 153
  • 2
  • 8
  • You've to "marry" the transmitter and receiver -- go through a little "ceremony" to get them to recognize each other. There will be a procedure for this in the instructions. (That said, the first wireless Cateye I got was no good and I had to return it for a replacement. Wireless is still not all that reliable.) – Daniel R Hicks Mar 18 '13 at 10:53
  • Thank you. I found out that the gap was just too big between sensor and the magnet. It is ok now. – Alex Buznik Mar 18 '13 at 11:07
  • 2
    Alex, on Stack Exchange sites, it's perfectly acceptable to answer your own question. Do you want to take your update and making it an answer? – Goodbye Stack Exchange Mar 18 '13 at 15:20
  • I wanted to, but yesterday could not because of the novice limitation (not allowed to reply your own question in under 8 hours) – Alex Buznik Mar 19 '13 at 09:45

1 Answers1

2

update After watching the installation video on the Sigma web-site, understood that the gap was too big between sensor and the magnet. So the sensor shouldn't parallel to the wheel, but pointing towards it -

Alex Buznik
  • 153
  • 2
  • 8