6

So, the wife got me a Creality Ender-3 Pro 3d Printer for Christmas.

Assembly was easy, axis movements are all solid... when I go to print the test-dog.gcode file provided with the machine, it comes out looking... flat.

Not kind of flat. TOTALLY flat.

The Z-Axis motor works - I can move it with the machine's control panel - and it moves on it's own for repositioning of the head for printing purposes, but it doesn't seem to be moving 'up' for each new layer. Layer height is set for 0.1 mm, nozzle is .4 mm. No settings changed in the G-code, or on the machine (and I did a "reset to failsafe" before attempting to print anything).

I'm relatively new to additive manufacturing, can someone help out here?

Photo of the test print

Trish
  • 22,722
  • 13
  • 53
  • 105
Darryl Hadfield
  • 81
  • 1
  • 3

3 Answers3

2

It turned out that there's something wrong with the G-code file that came with my printer.

I downloaded a calibration cube from Thingiverse and printed it - while it wasn't 100%, it did print viable. Now I need to get into details as to quality, and I suspect that too will be a factor for the G-code used in the printer. I'm looking at "Ultimaker Cura" to figure out the changes in G-code based on option changes.

0scar
  • 37,446
  • 12
  • 68
  • 156
Darryl Hadfield
  • 81
  • 1
  • 3
1

Check the following:

  • Is the lead screw bent? remove it from the assembly and have it roll down a very slightly angled plate - if it rolls at uneven speed, it is bent.
  • are the motor perfectly aligned with the brass nut? The lead screw needs to slot into the coupling without any force or need to move it just from gravity alone.
  • is the Z-axis nut spin easily? I gave mine a droplet or two of machine oil, motor it up and down the whole length twice. Some residue grease from the factory can bind up the motor.

If all the physical side is known to be OK: re-slice your object, you might have faulty g-code.

Trish
  • 22,722
  • 13
  • 53
  • 105
0

I had the same problem on an Ender 3. Totally bewildering, because G-code commands G0 & G1 moved Z as expected, as did Pronterface commands, but Z did not advance during printing.

It turned out to be binding in the Z-axis lead screw caused by installing a BondTech style extruder. Previously, it had caused no problems but reinstallation saw it interfering with the screw. A quick workout on the Dremel created sufficient clearance.

The clear conclusion is that during printing power to the Z-motor decreases for whatever reason.

Check your machine's alignment. The Z screw should turn easily by hand, the nylon wheels of the X gantry the same. The bracket mounting the extruder and lead screw is well known to be non-square. Check by releasing the lead screw from motor coupling and seeing where its 'natural' position is vs the coupling. If it won't fall close to the coupling naturally that could be the cause.

Then RTFM or punish yourself with 1000 YouTube instructionals.

agarza
  • 1,714
  • 2
  • 16
  • 33
Gareth
  • 1