My print popped out from the bed and glued to the nozzle. As the printer was printing next hour or so, a lot of pla was extruded and formed on the nozzle.
a remark: was trying to heat the nozzle over 180, but I am getting a thermal runout. The pla is hard, I don't want to broke the throat.
If you grab the blob with a pliers and twist, all or most of it may pop off. If not, heat the extruder up perhaps 10 degrees higher than usual, and wait for the external gunk to soften up and then pull it off.
Well, if it won't get hot enough, then try using an external source such as a soldering iron tip to cut off most of the mess, then it may be time for exacto knife blades and small files to remove the remainder.
Unless you're a clean freak :-) a little residue around the nozzle doesn't matter - it won't touch your prints and at some time in the future it'll be "cooked" enough to fall off.
I would suggests to use a heat gun and carefully warm up the PLA to be soft and remove it carefully like a big piece of Play-Doh. Using the extruder to heat up the PLA don't sound like the best idea, for me, because the inner PLA will be fluid and it could be a bigger mess than it is up to now.
