I'm making a pot for my plant where the top opening is larger than the bottom base and the top and bottom are circular (like the below picture). I used the Loft feature to connect the top and bottom circles. The only problem is that the Loft feature filled in the interior of the pot too. I thought that I could just negative extrude to get the opening back, but the taper angle is limited to 45 degrees, so I can't quite get the 106.6 degree angle I need to get the pot to look normal. I'm thinking of trying the Shell feature next, but I honestly don't know what I'm doing (this is my first time trying to CAD). Any help is appreciated!! 
Asked
Active
Viewed 55 times
1
kikothebirb
- 31
- 5
1 Answers
2
Loft top and bottom faces together, add vertical trapezoidal cross section sketch on any side view of pot, & revolve cut 360 degrees.
kikothebirb
- 31
- 5