Home Improvement Stack Exchange
Home Improvement Stack Exchange

Most Popular

more tags
1500 questions
13
votes
7 answers

How can I fix a Moen faucet that is still leaking after replacing cartridge?

I had a leaky Moen faucet (Moen 4600) so I removed the old cartridge and replaced it with a new brass replacement cartridge (model 1200.) Since replacing the cartridge I now have a leak from the valve stem, that leaks faster the more I open the…
Dave Forgac
  • 351
  • 1
  • 2
  • 9
13
votes
2 answers

Is it ok to wire light switches and lights with 12/2 cable?

It sounds like light switches and lights are usually wired with 14/2 cable. Is it okay to use 12/2 cable instead? Would I need special switches?
99miles
  • 231
  • 1
  • 2
  • 3
13
votes
5 answers

What is the best way to remove popcorn from the ceiling?

What is the best solution for removing popcorn from the ceiling if I want to get it to look smooth afterwards? Edit: thanks for your answers! Would you estimate that replacing the drywall on the ceiling would be less work/mess and result in a…
Rom
  • 498
  • 1
  • 6
  • 11
13
votes
5 answers

How can I protect my hands when using power tools?

When doing many DIY projects there's a strong need to protect hands against cutting by sharp part edges. Gloves seem a natural solution. However recently I was mounting a countertop and wearing gloves and I needed to drill a hole in the countertop…
sharptooth
  • 9,617
  • 20
  • 63
  • 87
13
votes
8 answers

What's the minimum recommended compressor HP/PSI to spray paint?

I have a little compressor that I use for a small brad nailer and blowing up tires. Is there a minimum PSI or horsepower that I need to be able to get to in order to spray paint with it?
MattGrommes
  • 673
  • 2
  • 7
  • 11
13
votes
4 answers

How to properly ground a subpanel in detached building?

I Will be installing a subpanel in a detached garage. The subpanel will be 60 amp. The garage is about 30' from the main-panel in-house, and I will of course get an exact length before selecting the proper gauge wiring. I'll be using pvc underground…
MDMoore313
  • 1,074
  • 6
  • 24
  • 38
13
votes
6 answers

How can I stop Lego bricks from falling in to a register?

My kids like to play with Lego bricks on the floor, and sometimes a small piece will fall in to a heating register. Sometimes I can pull them out, but usually they fall too far, and there are sharp edges that like to draw blood. Is there something I…
Jay Bazuzi
  • 11,698
  • 34
  • 97
  • 143
13
votes
4 answers

How do I fix a leaking connector between my garden hose and faucet?

I am trying to connect a garden hose with the faucet. After connecting and turning on the faucet, the water still squirted out. Please see the attached picture. I am not sure whether I need a wrench to tighten it, or it is just because the faucet or…
user297850
  • 387
  • 3
  • 6
  • 9
13
votes
5 answers

What are some pros, cons and recommendations for multicables?

Currently saving to build a new home and I'm going over wiring options in my mind. My current home has too few sockets, cable connections and LAN ports (yes I still like wired LAN, wireless is good but wired is faster). I'd like to solicit some…
user45
13
votes
5 answers

I have this light and I don't know how to open it

I would like to replace the bulb and I don't know how to do it. I tried pulling the clips on the side out, but they don't budge. Then I tried to unscrew the clips off (hence the third picture), but the screwdriver has to be used at an angle and…
smartypantstemple
  • 131
  • 1
  • 1
  • 3
13
votes
2 answers

What could be causing an orange flame on all appliances?

I have an orange flame in all my gas appliances (gas furnace, gas water heater, and gas stove) and cannot seem to determine the cause. Background So far, I have had the gas company come out. I had an appliance tech look at our stove, and tomorrow,…
Terry
  • 233
  • 1
  • 2
  • 7
13
votes
2 answers

How can I replace 2-prong receptacles in a code compliant way?

I have some 2-prong non-grounding type receptacles, and I'd like to replace them with 3-prong grounding type receptacles. According to National Electrical Code, what are my options?
Tester101
  • 131,561
  • 78
  • 320
  • 610
13
votes
2 answers

Can I leave drywall floating in the corners of my basement ceiling?

I was planning on installing drywall on my basement ceiling and realized that I have nothing to screw the drywall on after the last joist. On one corner of the room there is 12 inches from the last joist to the wall and on another side I have about…
user18234
  • 131
  • 1
  • 1
  • 3
13
votes
4 answers

In what orientation should this L-bracket be when hanging shelves?

I have a few L-brackets for hanging shelves. The brackets are asymmetric, where one L arm is longer than the other, just like a real "L" (similar to this). Is there a preferred or recommended way for which arm, the longer or the shorter, goes on…
Adi Shavit
  • 233
  • 1
  • 2
  • 7
13
votes
1 answer

What size wire should I use to feed a subpanel in my garage?

My main panel has been upgraded to 100 amps. I would like to add a subpanel in the garage which would supply: 20 amp Mig welder running on 120 volts, but later upgrade to a larger Mig welder as i am experienced at welding. Large jointer Medium…
Peter
  • 131
  • 1
  • 1
  • 3
1 2 3
…
99 100